I appear to have one that gets the jag/cleaning patch stuck by the breech. How did you overcome this and are able to do a good job cleaning the rifle? Any experienced helpful pointers are appreciated. Thanks!
I appear to have one that gets the jag/cleaning patch stuck by the breech. How did you overcome this and are able to do a good job cleaning the rifle? Any experienced helpful pointers are appreciated. Thanks!
Have the problem all the time, every time. It seems to bunch up when it gets to the breech and almost impossible to pull out and when i do get it out seems most time patch left in the breech. I have to use a vise. My solution, get a 22 wire brush and wrap the patch around it with an overlap on the bottom of the brush. Have not had one stuck since. It is like every jag i have is just to big with any patch. 22 brush gives it room to do its job. Wire is really not touching the bore but is flexible to allow the patch to not get stuck.Not a fouling ring...just been struggling with it since I built it from a kit...I read somewhere in my searches that there was a batch of them made that caused these hang ups but I didn’t see a real workaround/remedy. Something about a gap with the breech plug. And I’m using the tapered shaft jag from TOTW.
Nope, not a patch issue. I’ll try the .22 bore brush with cleaning patch and slotted jag solutions suggested...much appreciate that feedback.Are your patches too big ?
Swabbing after every shot with Moose Milk.How many shots before swabbing ?
Let me know how it works for you please.Nope, not a patch issue. I’ll try the .22 bore brush with cleaning patch and slotted jag solutions suggested...much appreciate that feedback.
Swabbing after every shot with Moose Milk.
Enter your email address to join: