So I decided to try to make a powder horn. I bought a horn at a local event and started watching YouTube. I ordered a carbide scribe to do all the carving work. I cut the horn about 1.5 inch from the end and drilled out the horn. To a scrap piece of oak and fit it to the end of the horn. Stained the wood. Then I removed a large section towards the tip. Not sure why but I seen a lot of pictures with it done and I like it. I found a few items I wanted to put on it. I used carbon paper to transpose it on the horn. Then I carved/scratched it in. I used sharpie marker for the ink. I'm not finished yet but I like how it's coming along. Let me know what you think. Any tip or advice is always welcome.