64Springer
75 Cal.
My Zoli Zouave has always had a problem with ignition. Fouling would clog the flash hole after two shots. And after swabbing, there would be a distinct delay in ignition. All of this was with #11 CCI Magnum primers.
This may have been covered before, but here is what looks like a good solution. Use a tapered Dremel bit to cone the flash hole. Thereby directing more flame into the chamber.
The rough marks can be cleaned up with a small dowel and lapping compound or a tapered Dremel stone. Or leave as is and clean the area well when done shooting.
I know I'm not the only person in muzzle loading land to have experienced this Zoli Zouave problem. Hope it helps.
This may have been covered before, but here is what looks like a good solution. Use a tapered Dremel bit to cone the flash hole. Thereby directing more flame into the chamber.
The rough marks can be cleaned up with a small dowel and lapping compound or a tapered Dremel stone. Or leave as is and clean the area well when done shooting.
I know I'm not the only person in muzzle loading land to have experienced this Zoli Zouave problem. Hope it helps.