• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades
  • Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

.45 Caliber: Deer?

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
In the open , and broken woods of Pa. late season winter deer hunt , shots can vary from short distance , to 125 yds. . I wouldn't be confident with .440 ball weighing 135 gr. Vs a .50 cal ball weighing 175 gr.. I shot competition with a .50 cal. longrifle , that shot flat out to 125 yds.. Also , this is another non judgemental note from experience. I was using my .50 longrifle shooting knock down steel targets , out to 200 yds. The .50 would knock the 200 yd. cub bear over , every time. I built a lighter .45 cal. rifle to use on the knock downs , and the .45 wouldn't knock the bear over , unless the hit was in the top of the head. Moral......The .50 has just a small amount more power , and distance for my hunting purposes. While I still could see the sights , , my overall favorite cal. was the .62..w/ 37 In. barrel length , St. 1 " oct , the 90 gr. ffg powder charge finally got too much for me. Trajectory , I think , at 100 yds. , sighted in 1" high , was 3" low at 200 yds. . Very manageable for deer hunting , for a young guy.
 
This question gets asked on a regular basis..... And interestingly enough, as often as it is asked it keeps getting asked,,,,,,, and the answers don't seem to change.

https://www.muzzleloadingforum.com/threads/yes-a-45-caliber-will-kill-a-15-point-buck….172117/

https://www.muzzleloadingforum.com/threads/45-cal-vincent-ohio-rifle-for-deer.173032/

https://www.muzzleloadingforum.com/threads/45-prb-load.173006/

https://www.muzzleloadingforum.com/threads/the-old-45-flinter-did-it-again.173172/

And these are just from the past few months, and only from the hunting section, never mind similar topics listed under Flintlock Rifle and Percussion Rifle,,,,, and older topic threads on the same subject in all three sections over the past years.
 
The one element that is left out of this discussion is the variable size and body mass of deer around the country. You can't really pigeon hole a caliber size on deer that may range from 125 lbs. In the deep south to 300 lbs in the upper mid west and north east.
Irrelevant.
A roundball from a .45 through the lungs will kill a 300 pound deer just as dead as a 100 pound deer.
Range and velocity/energy loss at distance might be more of a factor than the size of the deer. Especially given so many people's obsessed with how far they can shoot and animal.
 
Irrelevant.
A roundball from a .45 through the lungs will kill a 300 pound deer just as dead as a 100 pound deer.
Range and velocity/energy loss at distance might be more of a factor than the size of the deer. Especially given so many people's obsessed with how far they can shoot and animal.
That logic would indicate there should be no minimum caliber. I don't think so.
 
My dad has killed at least a 100 deer with his 45 TC. The 45 is easy to get some high velocity out of without crazy high powder charges. A 45 hole is a 45 hole. That roundball will pass through a deer out to 100 yards. A lead 45 roundball will poke the same size hole as a 45-70. As a matter of fact over a chrono I’ve measured 45 roundballs (80 grains 3F) that are way faster than my BP 45-70 military loads. No one will argue that a 45-70 isn’t equipped to kill a deer regardless of size. That’s why I used the comparison even though it’s probably a no-no. Yes the roundball is 127 grain and the 45-70 is 405 grain but negating the difference between a soft lead roundball and a hard cast 45-70 the soft roundball will thump harder and expand better, where the hard cast just pokes a hole.
 
Last edited:
I had a friend that used a .45 on a large Ohio Whitetail. After letting the deer lie for an hour, the tracking began. We saw the deer was only wounded in the shoulder (70 grains of 3F and .440 roundball). We tracked the big antlered deer to the Scioto river where the deer ran into the river and was never seen again. It was then I knew the .45 was not an adequate caliber for big bodied Ohio Deer. Losing that deer proved that. I shoot a .54 now. .45 caliber for large northern deer .... just say NO.
Ohio Rusty ><>
 
Last edited:
If legal in your state, do you consider the .45 caliber round ball suitable for taking a deer?

Thanks,

-Smokey
Maryland sika deer, 40-45 yards , 60 grains ,.440prb . Deer ran about 10-15 yards with not hardly any blood. Good thing i watched her and could easily see her drop!
 

Attachments

  • IMG_20240203_172512586.jpg
    IMG_20240203_172512586.jpg
    3.3 MB · Views: 0
If legal in your state, do you consider the .45 caliber round ball suitable for taking a deer?

Thanks,

-Smokey
Have taken many deer with 45 caliber muzzleloaders, both with round balls and conicals. First started hunting with a 06. Quickly learned that a shot from any angle or distance worked. With the 06.

Early on, hit a quartering towards me buck at a little over 100 yards and discovered limitations of a 45 caliber round ball. Perfectly ‘placed’ shot, bounced around shoulder/upper leg bones but never penetrated chest cavity. After a a long tracking session, aided by fresh snow, finished the deal. Lesson learned, shot placement can be critical depending on caliber. Same shot placement location with a 45 conical or 58 caliber roundball for example, little or no tracking. Had a 54 caliber TC ready to go before the following season and never looked back. And just as a side note, hunting regulations where I hunted at the time limited muzzleloaders to using roundballs only.

I have no problem using 45 caliber round balls for deer, but keep shots well under 75 yards, and make careful shot placement, much like when archery hunting. You need to wait for the right shot. It will not penetrate the chest cavity from any angle like larger balls or conicals will. As my high school football coach told me, ‘boy, you are just to light in the a$$ to play this game’.
 
Have taken many deer with 45 caliber muzzleloaders, both with round balls and conicals. First started hunting with a 06. Quickly learned that a shot from any angle or distance worked. With the 06.

Early on, hit a quartering towards me buck at a little over 100 yards and discovered limitations of a 45 caliber round ball. Perfectly ‘placed’ shot, bounced around shoulder/upper leg bones but never penetrated chest cavity. After a a long tracking session, aided by fresh snow, finished the deal. Lesson learned, shot placement can be critical depending on caliber. Same shot placement location with a 45 conical or 58 caliber roundball for example, little or no tracking. Had a 54 caliber TC ready to go before the following season and never looked back. And just as a side note, hunting regulations where I hunted at the time limited muzzleloaders to using roundballs only.

I have no problem using 45 caliber round balls for deer, but keep shots well under 75 yards, and make careful shot placement, much like when archery hunting. You need to wait for the right shot. It will not penetrate the chest cavity from any angle like larger balls or conicals will. As my high school football coach told me, ‘boy, you are just to light in the a$$ to play this game’.
And I rest my case
 
Back
Top