rkrcpa
32 Cal
Has anybody used the single trigger conversion kit on their Hawken Flintlock and if so, what were the results. Better trigger pull? Worse?
Indeed, googled and found it. An answer to a misunderstood question??they basically took out one trigger and sold the "kit". look at the trigger plate and the internal side of the plate.
have never tried one. just used the stock triggers singly, ignoring the set trigger.
Oh yeah, I remember when they offered that.they basically took out one trigger and sold the "kit".
I think he is asking about have a single trigger with a different geometry for a T/C.Why would you want to remove the double trigger?
The trigger is the same as not using the set not real good unless you are good at reworking the lock and triggerthey basically took out one trigger and sold the "kit". look at the trigger plate and the internal side of the plate.
have never tried one. just used the stock triggers singly, ignoring the set trigger.
Never seen what you are describing but have seen a lot of T/C packaging single trigger conversions still sealed up. And all they were was the standard double trigger plate without any of the set trigger parts installed. I was going to go that route for my competition smooth bore but the trigger was atrocious so I went with their renagade hunter trigger and gard and installed a custom trigger blade. And then worked the flintlock and trigger till I got a 2 lb break. Never won any matches ( couldn’t get around the no rear sight thing ) but it sure is fast and cleanI don't remember any empty slot for a back trigger, it was more like a Renegade single trigger, the trigger fit in the middle of the trigger guard not forward like a front trigger of a double set, it has been almost 50 years ago, my memory may not be up to snuff.
Enter your email address to join: