Buckskinn
45 Cal.
I'm at the point of drilling the pin hole for the single trigger. How far from the pivot point should the sear sit?
Are there any tips that will help me locate where to drill this hole? It seems like somewhat of a shot in the dark as to hit that little tab in the middle...
Also, the sear sits very low and it looks like most of that tab will need to be filed off. I assume that this will not be a problem??
Thanks!
Are there any tips that will help me locate where to drill this hole? It seems like somewhat of a shot in the dark as to hit that little tab in the middle...
Also, the sear sits very low and it looks like most of that tab will need to be filed off. I assume that this will not be a problem??
Thanks!