Started another horn

[S.Kenton]

It’s a very very slim horn to start with, nice slight double twist. It will make a nice elegant horn when I’m done.

 

[IanH]

That would be a good one for "scrimshantery" and a lathe-turned plug. Please keep us posted.

 

[HSmithTX]

That horn could end up fantastic. I'd be tempted to scrape the clear part of it back thin enough to be translucent, then decide how much further I wanted to take it.

 

[S.Kenton]

That horn could end up fantastic. I'd be tempted to scrape the clear part of it back thin enough to be translucent, then decide how much further I wanted to take it.

I actually thought of that, but a lot is going to depend on what it looks like when the body straightened around. Heck, I may have file enough back it might be transluscent anyhow.. lol

 

[S.Kenton]

A little more work, I’ve been working a lot of hours and busy with life… but I’ll get it done.. I decided to do an octagon design on the spout end, hard to see in the light that I had to work with, but I done the best with my pictures.

 

[lt508th]

A little more work, I’ve been working a lot of hours and busy with life… but I’ll get it done.. I decided to do an octagon design on the spout end, hard to see in the light that I had to work with, but I done the best with my pictures.

Looks nice so far!