• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Firing blanks from a flintlock rifle

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
We used a wad of florist's foam in c&b revolvers for a long time in the NM Gunfighters group. A smear of crisco over each chamber kept fouling soft and reduced chain fires. In long guns, plenty of loose powder (over 100 grns) if ramming not allowed and keep muzzle up. It goes kinda whooomphf!, not much of a bang but is convincing enough to the uninitiated.
 
Blank firing a flintlock.....
In my opinion this is the safest way to fire a flintlock rifle for demonstration purposes.
Use a paper cartridge filled with powder, say 70-80 grains.
Make sure the rifle is at half cock.
Tear one end of the paper cartridge away with your teeth.
Empty paper cartridge into the muzzle.
Lightly tap the butt against the ground as you wad the paper into a ball.
Withdraw the rammer/ramrod.
Ram down the paper making sure it's seated and not being pulled back up the bore by the ramrod. (This is why you do not use a jag affixed the rod to fire blanks)
Withdraw the ramrod and replace it in its thimbles and stock.
Make sure the rifle is never pointed at your face, body or others during the loading process.
The gun will be angled away from the loader. (You may want to look at "well trained" reenactors loading on the line.)
Bring the rifle up.
Don't point it at anybody, make sure muzzle down range and open the frizzen.
Uncap your horn and prime the pan.
Cap the horn.
Lower frizzen.
Hold the rifle at the ready.
While at the ready, double check that horn cap with your free hand.
Make ready.... shoulder rifle and cock it.
Take aim, make sure the muzzle is pointed in a safe direction.
Fire, pull the trigger.
Flash in the pan or missfire.
Give the loaded rifle a few moments.
Return the rifle to the "ready" or at arms.
Return the rifle to half cock.
Check prime. If powder is still there, turn the rifle to empty prime.
Retrieve a cloth from your pouch wipe pan and frizzen.
Retrieve a pick or feather, pick touch hole.
Retrieve a new cartridge.
Tear and prime.
Drop cartridge to the ground. Stand on it with your foot.
Make ready, take aim, fire.
If it misfires again the shooting demo is over!!! You'll have to work on your gun?
Remember the cartridge under your foot.
Empty it and throw the paper away.

Why do I recommend ramming the load?
It's simple. Repeated blank firing of a BP arm fouls the bore. Too much fouling can cause a barrel obstruction. A small bore gun like a rifle will foul much more quickly and with less shots than a musket.
The worst-case scenario is that half the charge falls past the fouling/crud ring to the breech while the rest sticks and plugs the bore at the crud ring. When the gun is fired the breech ignites followed by the powder at the obstruction. This causes a double shock wave exploding the barrel.
^^^^ This explains the mystery explosions during reenactments. The cause.....a dirty fouled obstructed barrel.
Ramming down the charge corrects this.
Keep in mind this is for demo and not against opposing forces.
 
I use bread in my .69 bore cannon,no paper to make a mess.Ive never tried to shoot blanks in rifle or handgun,but don't see why it wouldn't work just use a smaller glob of mashed bread.
 
Back
Top