PaulTBarton
40 Cal.
- Joined
- Nov 7, 2006
- Messages
- 128
- Reaction score
- 0
I replaced the fly with a NOS part. The old fly was too worn down to hold full-cock.
This new fly cannot hold full-cock either as the sear just slides down until it releases the hammer.
The fly face (the part that contacts the sear) is not at right angles to the hammer pivot, hence the sliding. The sear seems not broken or worn at the tip.
How much can I adjust that fly face to get this lock to function correctly?
Thanks,
IdeZilla
ala BartSr aka PaulTBarton
Mesa, AZ.
This new fly cannot hold full-cock either as the sear just slides down until it releases the hammer.
The fly face (the part that contacts the sear) is not at right angles to the hammer pivot, hence the sliding. The sear seems not broken or worn at the tip.
How much can I adjust that fly face to get this lock to function correctly?
Thanks,
IdeZilla
ala BartSr aka PaulTBarton
Mesa, AZ.