SOLD InvestArm 50 Caliber Hawken Flintlock $475 reduce to $425 to $400

[npl6166]

InvestArm 50 Caliber Hawken Flintlock $475 Reduced to $425 $400. Plus UPS shipping from 48316
28.75” Barrel
Believe to be 1:48 rate of twist
Muzzleloader looks hardly used
Couple of minor nicks on rear near patch box
Slight warp bubble between butt plate and patch box

See pictures below and additional in comments

 

[npl6166]

 

[npl6166]

Back to the top

 

[npl6166]

Bump

 

[azmntman]

Photo of touch hole/pan alignment? Sparker? Have you fired this one? Chrome lined barrel?
My caplocks In Investarms are awesome rifles.

 

[npl6166]

Photo of touch hole/pan alignment? Sparker? Have you fired this one? Chrome lined barrel?
My caplocks In Investarms are awesome rifles.

 

[azmntman]

Thank you.

 

[dneprdude]

Good rifle.

 

[Tumbledown]

How does a stock bubble like that by the butt plate?

 

[texasred]

I will take it. How do you want your money?

 

[npl6166]

$400 Plus UPS shipping adult signature required - normally cost $35ish but I'll take $425.00 total shipped. USPS money order or Walmart Money gram.
PM me for address.

 

[npl6166]

Bump

 

[rusticbob]

Is this still for sale?

 

[npl6166]

Yes

 

[R1GT]

How does a stock bubble like that by the butt plate?

As a…whatever the opposite of an expert is, but someone who has worked with plenty of wood…my best guess would be recoil against the metal split the wood along the grain causing that flake to lift up.

Id be willing to bet you could pull that butt plate off, drive some wood glue deep into the split, and clamp it up for a day or so and it would probably be good to go.

Again, in my very not expert opinion.

If I didn’t already have a 54 hawken flintlock id probably scoop this up and do just that.

 

[npl6166]

Thank you