-
This community needs YOUR help today. With being blacklisted from all ad networks like Adsense or should I say AdNOSense due to our pro 2nd Amendment stance and topic of this commmunity we rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.
Sign up here: https://www.muzzleloadingforum.com/account/upgrades
Help Support Muzzleloading Forum:
waarp8nt
- Messages
- 890
- Reaction score
- 1,708
Latest activity Postings About
-
-
waarp8nt replied to the thread flint and frizzen.Take some pictures and post them. It will help folks determine what you need to do. -
Got any photos?
-
waarp8nt replied to the thread WANTED T/C, Lyman or Interarms Flintlock lock assembly.Bump for the Weekend.
-
waarp8nt reacted to French Colonial's post in the thread If I wanted a buffalo rifle..... with
Like.
Yes agree completely, The buffalo/bison east of the Mississippi were all killed by smoothbores and rifles (and quite a few arrows)... -
This. Had to do this to a Traditions Deerhunter, though not as bad as yours. Go a little at a time as it's easy to go to far and have to...
-
I'm a rookie at best, and the picture is out of focus, so it could be an illusion, but it looks like the barrel is not clocked correctly...
-
waarp8nt replied to the thread Hammer/nipple alignment..It does look somewhat off, that would certainly be a place to start. Good catch.
-
waarp8nt replied to the thread Hammer/nipple alignment..If you have a torch, you can remove, heat and bend the hammer. Reinstall or repeat as required to get the proper fit. I would put the...
-
I was considering making one, but switched to a caliver because the barrel was available. I have attached some plans I found online, to...
-
I figure they're not Phillips at all, just cross cut screws that can be turned by a straight screwdriver turned either of two ways.
-
I am new to muzzleloaders, however I like machine work and unusual products. I have used Muggyweld on quite a few projects and have had...
-
waarp8nt replied to the thread WANTED T/C, Lyman or Interarms Flintlock lock assembly.Bump
-
I'll measure when I get home. Tomorrow if I'm lucky.
-
waarp8nt replied to the thread WANTED T/C Rear Sight..New Englander sight would be mounted to a round barrel and the White Mountain sight bolts to the flats. So, the sight base is shaped a...
-
NO do not blue the bore! Get a light and check the bore for any rust or pitting.
-
-
Loading…
-
Loading…