Well I made a very foolish mistake. After fitting the butt plate on my bucks county rifle I drilled for the screws and somehow managed to get the top screw off center. At first I thought I could fix it when I countersunk the screw but it just wasnt good enough so I decided to braze the hole full and re-drill. I tried it with just a propane torch and I couldnt get the braze to stick, I'm thinking it wouldnt stick because the butt plate wasnt hot enough. I have access to an oxy acetylene torch. So if you guys could help me out, maybe give me some pointers, I would greatly appreciate it. Is there any surface preparation I need to know about, etc. Thanks in advance.
Little Brother
Little Brother