justafeedboy
36 Cal.
- Joined
- Feb 23, 2006
- Messages
- 54
- Reaction score
- 0
I am in letting my lock trying to get the flash pan touching the barrel, I have taken the lock all apart and have inlet it and then added a piece at a time and continued to inlet it. I am nearing completion of this process now I need to scrape out a high area to allow it to go from half cock to full cock. While cleaning a relatives garage I came across a feeler gauge. It is numbered 25 and goes down to 1.5. My previous high tech gauge was a piece of paper. Is there any gap or measurement that I should strive for. When I found this feeler gauge it opened up a whole world of possibilities in my mind for uses.