I pin whenever I can. As to original guns, you see more screws on poor boy mountain rifles than on Pa. rifles from known builders. Pinning, especially if the TG is inletted, seems much more secure. Semper Fi.
-
This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.
Sign up here: https://www.muzzleloadingforum.com/account/upgrades -
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Trigger guard install
- Thread starter Peter de KAM
- Start date
Help Support Muzzleloading Forum:
Col. Batguano
75 Cal.
- Joined
- Feb 10, 2011
- Messages
- 5,034
- Reaction score
- 1,407
You should wait on doing your drilling (of the metal tabs) for pinning until just after the stock is dyed, or even finished. Those holes need to be cleaned up from varnish that gets in there after the gun is finished anyway. The reason for this is the stock dimensions are going to swell slightly during all your whiskerings and other applications of wetting agents (water, stain, finish) and the holes might not line up perfectly when you're doing your final assembly. If you do it before this you might wind up with a TG that the pins won't go through (too tight) or the TG sits too high to the stock (too loose). Go ahead and drill the holes for the wood, but leave the metal tab till later
Tip; Don't try to drill through the metal tab all the way while the tabs are in the stock, especially if it's a brass TG. Brass is a particularly "grabby" metal for drill bits and can easily break off a bit inside the stock. Then you're in a world of trouble. The hardened tool steel of drill bits is just about impossible to drill out with another bit. Just stick your bit in there to START the hole and mark it, and then remove the TG and drill it completely through on your drill press.
Tip; Don't try to drill through the metal tab all the way while the tabs are in the stock, especially if it's a brass TG. Brass is a particularly "grabby" metal for drill bits and can easily break off a bit inside the stock. Then you're in a world of trouble. The hardened tool steel of drill bits is just about impossible to drill out with another bit. Just stick your bit in there to START the hole and mark it, and then remove the TG and drill it completely through on your drill press.
“Tip; Don't try to drill through the metal tab all the way while the tabs are in the stock, especially if it's a brass TG. Brass is a particularly "grabby" metal for drill bits and can easily break off a bit inside the stock. Then you're in a world of trouble. The hardened tool steel of drill bits is just about impossible to drill out with another bit. Just stick your bit in there to START the hole and mark it, and then remove the TG and drill it completely through on your drill press”
Great advise!!
Great advise!!
