RhinoDave
40 Cal.
I picked up a used Hawken that had been personalized with the intention of refinishing it as long as it shot fairly well. It passed the shooting tests so I am finally getting around to redoing it. The wrist is pretty thick and the side plates aren't very well defined so those are areas that will get a lot of attention. Any thoughts or suggestions would be welcomed as I get into this project. Here's a couple of before and during picts after a few minutes with a rasp.
As of right now I plan on stripping whatever finish is left after alot of reshaping and just using tung oil or tru oil on the walnut stock.
As of right now I plan on stripping whatever finish is left after alot of reshaping and just using tung oil or tru oil on the walnut stock.