• If you have bought, sold or gained information from our Classifieds, please donate to Muzzleloading Forum and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

WITHDRAWN LAST REDUCTION Custom .54 Flint Longrifle

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Status
Not open for further replies.
Joined
Apr 9, 2014
Messages
2,116
Reaction score
2,314
Location
SE CT
42" Green Mountain Barrel, 1" ATF, originally a .50 caliber but re-bored by Bobby Hoyt to .54 with a gain Twist (1:70-1:48) round bottom grooved rifling for patched round balls. L&R lock, Single phase double set triggers, Maple stock with brass inlays, and a Sliding wood patch box. Small tomahawk figure burned into the wood by the toe plate. BEST OFFER OVER $850.00
Postal Money Order Only. PLUS SHIPPING to lower 48.
 

Attachments

  • .54 Flint Bobby Hoyt 001.JPG
    .54 Flint Bobby Hoyt 001.JPG
    253.3 KB
  • .54 Flint Bobby Hoyt 003.JPG
    .54 Flint Bobby Hoyt 003.JPG
    166.2 KB
  • .54 Flint Bobby Hoyt 004.JPG
    .54 Flint Bobby Hoyt 004.JPG
    224.3 KB
  • .54 Flint Bobby Hoyt 005.JPG
    .54 Flint Bobby Hoyt 005.JPG
    146 KB
  • .54 Flint Bobby Hoyt 006.JPG
    .54 Flint Bobby Hoyt 006.JPG
    226.5 KB
  • .54 Flint Bobby Hoyt 009.JPG
    .54 Flint Bobby Hoyt 009.JPG
    288.4 KB
  • .54 Flint Bobby Hoyt 010.JPG
    .54 Flint Bobby Hoyt 010.JPG
    239.2 KB
  • .54 Flint Bobby Hoyt 011.JPG
    .54 Flint Bobby Hoyt 011.JPG
    182 KB
  • .54 Flint Bobby Hoyt 012.JPG
    .54 Flint Bobby Hoyt 012.JPG
    254.4 KB
  • .54 Flint Bobby Hoyt 013.JPG
    .54 Flint Bobby Hoyt 013.JPG
    177.7 KB
Last edited:
What kind of touch hole liner is this and is this the Manton lock? Thank you.

Also, I assume the barrel is straight 1” full length and not swamped.
 
I believe the lock is a L&R, but am not 100% sure. The barrel is straight 1" ATF by Green Mountain, and the touch hole liner is a RMC hex wrench end liner for easy install and removal.
 
Grimord, if you get your camera figured out - a clearer, in focus picture of the muzzle / rifling would help also. Thanks, Easter
Here are some additional photo's. As for the muzzle and bore, I took a picture of the work order from Bobby Hoyt. The work was done in April of 2022.
 

Attachments

  • IMG_0786.JPG
    IMG_0786.JPG
    105 KB
  • IMG_0787.JPG
    IMG_0787.JPG
    217.9 KB
  • IMG_0788.JPG
    IMG_0788.JPG
    206.7 KB
Status
Not open for further replies.

Latest posts

Back
Top