Adjust half cock on TC Hawken

[bat119]

Is there some way of adjusting the half cock hammer position?
On one of the 54 Hawken's the hammer is too low to cap without pulling back the hammer then easing it down, not my favourite way of capping

 

[BruceHH]

Short answer, no there is not.

 

[Kansas Jake]

Most of my TCs can’t be capped at half cock. Just the way they were made.

 

[Splitear]

Not at all uncommon. Both my TC Hawken and New Englander are that way, the hammer is barely off the nipple at half cock. I don't believe there's a way to change that.

 

[akroguy]

My GPR is like that. Seriously annoying.

 

[bat119]

Ok that answers that, on my others there's some room this one is really low oh well I'll live with it
Thanks for the reply's

 

[Phil Coffins]

The only way I can think of is make a new sear that has the tip longer, then both the half cock and full will be higher.

 

[TDM]

That problem is common to TCs @bat119

 

[Buckskinquin]

Is there some way of adjusting the half cock hammer position?
On one of the 54 Hawken's the hammer is too low to cap without pulling back the hammer then easing it down, not my favourite way of capping

I just checked my L&R replacement lock on my Renegade, no room to cap at half cock with it either.

 

[OldRust]

@bat119 Check your nipple. TC had an early and a late hammer on their percussion locks. The early used a longer/taller nipple and the later took a shorter nipple. You may have a later hammer with the early nipple. See the photo for the different hammers. The short TC nipple at Track of the Wolf also

Thanks,
O.R.