It builds up in the bore, resulting in holding fouling when you are cleaning the gun.Can you say me what is the problem with bee wax ?thanks
It builds up in the bore, resulting in holding fouling when you are cleaning the gun.Can you say me what is the problem with bee wax ?thanks
I haven't mixed it with anything to make bore butter. But I have been using straight coconut oil for patch lube for a long time and it works great for meHi. I’m new here, but a muzzleloader enthusiast for years. I know there’s a lot of options out there, and just as many recipes for bullet and patch lube for muzzleloaders. I am using BP for propellant and have used T/C Bore Butter as a lube for many years. I do like the idea of a non petroleum “natural” lube and with the now scarcity of T/C products, have decided to try to make some of my own lube. A good friend who casts bullets for a living, and also makes his own BP lube, uses Beeswax and olive oil. I was going to do this myself, but then I read somewhere that as far as ph was concerned, that coconut oil was much more neutral. Seems to me that would be a good attribute, and thus a coconut oil/beeswax mixture might be a better alternative. What do you all think?
Good to hear. I was wondering since the ph is neutral, if coconut oil would have enough lubrication properties? Another concern is that it seems to have a very low melting point. (Then again, olive oil is already liquid at room temperature, so well, what the hey!) - JI haven't mixed it with anything to make bore butter. But I have been using straight coconut oil for patch lube for a long time and it works great for me
Probably a great lube. I dropped it because of that melting point. Too much hassle to anticipate what it will do next. Mixing it with other substances may be one option but while the mixture may not liquefy at 76f and above it will change the viscosity of the mixture on warm days and cold days. It just makes it impractical to have to adjust the methodology of it's use. It's probably fine if your practice is to lube quantities of patches in advance at home or wherever. Not a good idea to fill the grease hole in the stock of an SMR with it.Good to hear. I was wondering since the ph is neutral, if coconut oil would have enough lubrication properties? Another concern is that it seems to have a very low melting point. (Then again, olive oil is already liquid at room temperature, so well, what the hey!) - J
Ok, excuse my ignorance … what is an “SMR”?Probably a great lube. I dropped it because of that melting point. Too much hassle to anticipate what it will do next. Mixing it with other substances may be one option but while the mixture may not liquefy at 76f and above it will change the viscosity of the mixture on warm days and cold days. It just makes it impractical to have to adjust the methodology of it's use. It's probably fine if your practice is to lube quantities of patches in advance at home or wherever. Not a good idea to fill the grease hole in the stock of an SMR with it.
That’s great. I’m sure it would work well. But bear oil isn’t something you just pick up at any local store. I think I’ll try the beeswax and coconut oil.TOW Mink Oil mix in pure Bear Oil to desired consistency (I like it about like toothpaste), keeps the mink oil from hardening in extreme heat cold and the Mink oil makes the Bear oil from becoming water-like in hot weather.
I've not seen TOW at any of my local stores either...I gotta find better places to shopThat’s great. I’m sure it would work well. But bear oil isn’t something you just pick up at any local store. I think I’ll try the beeswax and coconut oil.
Enter your email address to join: