I was reassembling my brass frame Navy replica when I realized that the barrel wasn't quite lined up properly. When I pulled the barrel back off to see what was wrong, I found that both of the alignment pins that hold the barrel in line with the frame were missing. :curse: The gun is a CVA which I believe is made by Pietta.
Does anyone know if these pins are replaceable and or can this situation by corrected? :no: I am definitely not going to be shooting this revolver until I get this repaired. It seems to me that these were a press fit in the frame and a slip fit into the barrel assembly.
Does anyone know if these pins are replaceable and or can this situation by corrected? :no: I am definitely not going to be shooting this revolver until I get this repaired. It seems to me that these were a press fit in the frame and a slip fit into the barrel assembly.