- Joined
- Oct 15, 2005
- Messages
- 162
- Reaction score
- 3
I have a this revolver that is in need of parts and advice. I received the piece as being locked up, it was, nothing would move, barrel wedge had to be drifted out, hammer screw was partly backed out and bound. Once dis-assembled, screw threads cleaned up and frame reassembled, cylinder slid in place, it will function fine.
The problem starts when you try to install the barrel, the pins in the frame hit a 1/32 approx. above the holes in the barrel assm. Force the pins in place and start the wedge, the piece is locked again.
On original clean up the residue in the barrel indicates, the gun may have been fired with smokeless powder.
I'm thinking the cylinder pin is bent.
So I need advice on removing this pin and where to find replacement along with the trigger guard screws.
The problem starts when you try to install the barrel, the pins in the frame hit a 1/32 approx. above the holes in the barrel assm. Force the pins in place and start the wedge, the piece is locked again.
On original clean up the residue in the barrel indicates, the gun may have been fired with smokeless powder.
I'm thinking the cylinder pin is bent.
So I need advice on removing this pin and where to find replacement along with the trigger guard screws.