Recent content by painter

Help Support Muzzle Loading Forum:

  1. painter

    Handles for Lyman molds - do others work? Dixie .58 swaging die?

    Lee double cavity molds have the handles permanently attached. This what you want for the Lyman molds... Handles, for bullet mold, LEE Commercial mold handles for six cavity molds, also fit Lyman, RCBS and similar mold blocks. - Track of the Wolf
  2. painter

    .355 cal. round ball?

    Lee no longer lists a .355 mold. Not saying that they never did.
  3. painter

    BP Shooting in Massachusetts/NH

    I belong to the Pemi F&G, in NH. Most weekdays the ranges are empty.
  4. painter

    Poured some lead today.

    Thanks again!👍
  5. painter

    Poured some lead today.

    Thank you. Beeswax?
  6. painter

    Poured some lead today.

    As a casting know nothing, what does the wax do?
  7. painter

    WARNING: A too good deal is probably a too good deal if from a stranger.

    Some forums also don't allow personal messages from new members until a certain number of posts/length of time.. That would stop this particular guy.
  8. painter

    Neeeeext!

    Dave, You've never made a piece of crap, so no possible way of 'passing anything off'.
  9. painter

    Black Powder/muzzleloaders in VT

    You might try LL Cote in Errol, NH...603-482-7777 x 102
  10. painter

    I need a recommendation for professional grade gunsmith screwdrivers

    I really like my Magna-Tip set. Had one bit that twisted, and a short handle that spun on the shaft and Brownell's replaced them quickly with no questions asked.
  11. painter

    .36 Conundrum

    Be that way.:p You're obviously right. I just get a little OCD sometimes.
  12. painter

    .36 Conundrum

    I've pumped water through the patent breeches until the water ran clean. I still got fouling from them when I stick a q-tip and a little moose milk in there. The way a q-tip fits in a 8-32, or 10-32 thread, it's not falling off, and it isn't so tight in the patent breech that it won't fall out...
  13. painter

    .36 Conundrum

    I have a Pedersoli Frontier percussion in .36. I use 3 Fg. What I do to clean out the patent breech is to thread a q-tip into the end of my cleaning rod and slide it into the small diameter of the breech. After cleaning, and drying, I'll use a clean q-tip to put a little oil in the same area.
  14. painter

    How to use the bear grease…?

    I bought some of Frontier's Bear Oil lube. I melted it, soaked one patch, and layered a patch on each side of that one. Blotted any excess off while it was still liquid between paper towels. Stored the lubed patches in an old prescription bottle. They're slippery, but you can't tell there's...
  15. painter

    What Muzzleloading Stuff Did You Do Today?

    Thanks for the link. Ordered.:thumb:
Top