Help Support Muzzle Loading Forum:

flntlokr
Reaction score
508

Latest activity Postings About

    • flntlokr
      I make my liners from 14x28 set screws with Allen sockets. Easy to remove/replace, and allows for easy attachment of a fitting for...
      • Air extractor5.JPG
    • flntlokr
      flntlokr reacted to Griz44Mag's post in the thread Slotted vs non slotted vent liner with Like Like.
      First - when I was using a slotted liner I never had any issues with fouling. I did have issues with being able to use that shallow and...
    • flntlokr
      flntlokr replied to the thread Hello from southern B.C..
      Welcome back! Where are you situated? Are you planning on going up to Heffley Creek for the BC rendezvous this year? Usually lots of...
    • flntlokr
      flntlokr replied to the thread Rear sight on a smoothbore.
      They usually call them 'smooth rifles' these days. WRONG! a rifle is a firearm with a screw thread that spins the ball for better...
    • flntlokr
      flntlokr replied to the thread Sharpening flints?.
      I would think that by the time a flint has been reknapped and used to the point of being un-knappable, yer done. To grind/cut a usable...
    • flntlokr
      flntlokr replied to the thread Tiller length..?.
      I think that originally they used pike staffs for tillers, and those would have been even longer than 4'. In the day, they would...
    • flntlokr
      flntlokr reacted to hanshi's post in the thread What caliber is the flattest shooting? with Like Like.
      LD beat me to it but I agree that no BP rifle can be considered as shooting "flat". This is especially true when shooting round ball...
    • flntlokr
      I had to make a new fly for a lock at one time; the original had worn down to the point that it would no longer carry the sear reliably...
    • flntlokr
      As stated the problem is in the fly operation. Besides making sure the fly is moving correctly,test the lock out out the gun ,and look...
    • flntlokr
      The fly is in backwards or frozen in position.
    • flntlokr
      If you are using one of those short starters with a ball; lose the ball! Get a small piece of wood and make a mallet head about the...
    • flntlokr
      flntlokr replied to the thread Powder horn help!!!.
      Make sure that whatever horn you make for the nephew will hold enough powder for him to do a complete trail walk (at least) Annoying to...
    • flntlokr
      I usually pump water/soap throught the nipple a few times so the high pressure will clean it as you say. Then I pull the nipple so I...
    • flntlokr
      flntlokr reacted to Doc's post in the thread how to pull a ball with Like Like.
      Normally get two to three uses off of each cartridge. At Walmart if I remember correctly the cartridge runs for a box ten about $5. I...
    • flntlokr
      flntlokr replied to the thread how to pull a ball.
      Make one of these and keep it in your kit. Use any compressor or a bike pump. Thred the small end the same as your nipple threads...
      • Air extractor5.JPG
  • Loading…
  • Loading…
Top