• Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Dumb question?

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

scooter3844

32 Cal
Joined
Jun 20, 2015
Messages
48
Reaction score
7
Have a CVA mountain rifle that shoots 3 inches left at 25 yds. Now comes the dumb question. Should I bump the rear sight to the left or move the the front sight to the left. Its been along time since I tried to move sights.
 
The way I remember is as a kid I had a daisy BB gun. It had the elevated rear ramp sight you raise to shoot higher/farther distance. The front sight is just the opposite. May seem odd but I think about that and that's how I remember.
 
To adjust sights, typically you will move the front site toward the direction of the miss. For example, if you're missing left, move the front sight left. This will adjust the POI back to the right. In regard to the rear sight, you will move it opposite of the direction you're missing. If your hitting to the left, move the rear sight to the right. This would work the same when adjusting for elevation. I hope this helps.

Jeff
 
Thanks everyone. I'm gonna try to get it sighted in over the next day or so then try out to 100 yds.
 
Honestly it still confuses me sometimes. Have to ponder it a bit. Guess it comes from too many years of using scopes.
It confuses me also, but only because I am an old fart. Really, just remember: back sight going up/down, left/right, will move the bullet respective of direction, front sight does just the opposite.
Flintlocklar 🇺🇸
 
It confuses me also, but only because I am an old fart. Really, just remember: back sight going up/down, left/right, will move the bullet respective of direction, front sight does just the opposite.
Flintlocklar 🇺🇸
The sights remain aligned on target. You are really moving the rifle.
 
Dumb questions are asked by the below:

1. Spouses
2 Children
3. Bosses

I keep a 3 or 5 ring binder.

In it, is pertinent information for shooting in general and specific to each rifle and pistol.

The first section contains information such as which way to move the front and rear sights. It contains information on each mold such as diameter of each and the number of grains for each mold. Wind drift and elevation to 100 yards.

Next section is specific to each rifle and pistol. Make and model number of each, serial number of each, ball size, cap size, nipple size and thread diameter, and number of grains of powder, (minimum and maximum), powder grains for 25, 50 and 100 yards, patch diameter and lube . The book leaves nothing to chance nor a failing memory.

Each shooting venture is written down with comments.
 
Back
Top