-
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Tang Mount Sight-Protect Bluing ?
- Thread starter Sage1
- Start date
Help Support Muzzleloading Forum:
Put whatever wax or rust protectant on the tang and don’t worry about. If you remove the sight at a later date and decide the tang wasn’t protected enough, the tang comes out of the stock by removing two screws and can easily be refinished.
kelvinator
32 Cal.
In the past I have used a thin piece of plastic such as old credit/debit card and cut a shim the shape of the sight base to go between it and the tang.
OldNo7
36 Cal.
I've always used 2 layers of black electrical tape -- and you can trim it with sharp scissors to match the base; pre-cut holes with a hole punch as needed. Works great!
Old No7
Old No7
