WANTED WTB 54

[Mtman725]

I hope this works. The trigger can be over cocked if not careful. I've just gotten used to it. Pop the side plate off to reset.
1" X 32" bbl. A couple of small dents in the wood.

That's a good look gun hows it shoot? I'll give it a try. Thanks

 

[Shortgrub]

I loaded it with 75 grains FFG, .530 ball and a .015 patch. I manage to get 5 shots in one raged hole at 25 yds. several times. Like I mentioned, you have to beware of over cocking the hammer. It would help to have a bit heaver trigger spring.

 

[Mtman725]

I loaded it with 75 grains FFG, .530 ball and a .015 patch. I manage to get 5 shots in one raged hole at 25 yds. several times. Like I mentioned, you have to beware of over cocking the hammer. It would help to have a bit heaver trigger spring.

Ok I am thinking.

 

[Shortgrub]

Just wanted to open about the trigger. It's a very simple trigger.

 

[Mtman725]

Thank you for being honest.

 

[Flint Lockman]

I have a Thompson Center Hawken in .54 if you’re interested

 

[Mark Herman]

I have a nice .54 half stock custom but it's a lefty. Oregon barrel, single trigger and excellent condition throughout. Barrel has not been shot that I can see.

 

[Mtman725]

Man to bads its a South paw. That's what I am looking for.

 

[JeffWLee]

I have a nice .54 half stock custom but it's a lefty. Oregon barrel, single trigger and excellent condition throughout. Barrel has not been shot that I can see.

Mark, I sent you a message. Am a lefty; looking for more info.

 

[Loyalist Dave]

Folks if you want to talk prices, you MUST PM the original poster if replying to a Wanted ad.

IF you're not the OP and you get interested in what somebody has mentioned to the OP..., again a PM is needed.

LD