I'm building a Jaeger rifle. Most of the parts I sourced through TOW, but I sourced the barrel directly from Rice, and the stock from Petronica (spelling ?, I'm a couple beers in so who knows if I got that spelled right). The front swing swivel TOW sent me is only 15/16" on the inside dimension. I looked at there site and did not see anything bigger for the inside dimension, but the scaled drawing for the Jaeger they sent me shows the inside dimension for the swing swivel measuring 1-1/8". Everything else on that drawing is scaled right, so I expect it's right on that too. Well getting back to brass tax, the swing swivel I have to too small at 15/16". Even the barrel is a bit larger than 15/16 at that point and the swivel supposed to go around the stock (which is wider than the barrel at the point of the trunion it goes through).
let's get to the bottom line. I need a swing swivel approximately 1-1/8" on the inside. Who would be a good location to source the needed swivel.
let's get to the bottom line. I need a swing swivel approximately 1-1/8" on the inside. Who would be a good location to source the needed swivel.