I have used both, lithium grease for a while and oil now. I prefer oil since the fouling buildup in front of the cylinder isn't mas bad. What do you guys use and why?
-
This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.
Sign up here: https://www.muzzleloadingforum.com/account/upgrades -
Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.
We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.
Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103
Grease or Oil on the Arbor
- Thread starter fishmusic
- Start date
Help Support Muzzleloading Forum:
64Springer
75 Cal.
Grease.
Because grease stays put.
It's why arbors are grooved or undercut.
Because grease stays put.
It's why arbors are grooved or undercut.
I use Bore Butter. I also load off the gun. So it's easy to add Bore Butter as needed.
Greasecookie
36 Cl.
- Joined
- Nov 25, 2018
- Messages
- 70
- Reaction score
- 65
Finish Line bicycle grease. Just cuz I have it to grease bicycles. Any grease would work fine.
grease for friction, oil for protection.
Usually use grease, trying some anti seize thread protector
Old armorer's axiom: If it rotates, oil it. If it slides, grease it.
That cylinder is not spinning like a car wheel.
That cylinder is not spinning like a car wheel.
When I packed wheel bearings I packed them with grease . . . not oil . . .
"What" you use serves specific purposes. A problem with bp revolvers is fouling getting between the arbor/ base pin and the cylinder. So, both oil and grease will lubricate but grease will do a much better job of keeping fouling out than oil.
Mike
"What" you use serves specific purposes. A problem with bp revolvers is fouling getting between the arbor/ base pin and the cylinder. So, both oil and grease will lubricate but grease will do a much better job of keeping fouling out than oil.
Mike
Last edited:
Wow! I got some answers and looks like I will change my ways.
rodinal220
36 Cl.
Ballistol, or sometimes if I'm out of aerosol Ballistol some spray cooking oil.
Lucas' "Red N' Tacky" synthetic grease. Same stuff I use on my wheel bearings, u-joints, and other places one commonly uses grease.
RIG gun grease on arbor, put cylinder on, smear gun grease around front of cylinder at arbor enterance to keep fouling from getting into cylinder / arbor hole. Works for me.
64Springer
75 Cal.
Unless someone has been able to increase their cap n ball cylinder RPM to that of Dillon Minigun, any lubricant will work to some degree.
Creamy peanut butter would work in a pinch.
Creamy peanut butter would work in a pinch.
I use white lithium grease on the arbors of my Colt-style revolvers. Remingtons get Ballistol on the cylinder base pin. I will pull the pin after 2 or 3 cylinders full, wipe it down, and relube.
I also use Ballistol on my Rogers & Spencer but that doesn't require me to pull and lube the pin after a few cylinders, because the front of the cylinder has a gas shield.
I also use Ballistol on my Rogers & Spencer but that doesn't require me to pull and lube the pin after a few cylinders, because the front of the cylinder has a gas shield.
