George Brammer (Lawrence County Ohio & West virginia) heavy chunk gun in excellent condition including bore. very early rifling machine with 100+...
Depending on the insert and what the front Sight insert is, it should work. I would use the same sight both front & rear with a small peep...
I've had a number of UH rifles over the years with various modifications. One that I have kept is a H&A .45 with a 42" barrel that I put a one...
If you are going to have Hoyt re bore the barrel that should take care of the tool chatter, at both ends of the barrel. No need to shorten.
Capt, Not sure who you are asking about the barrel? It isn't me.
Understand, my mistake.
Sorry, didn'see "barrel".
I have a single barrel 12 GA built on a TC New Englander stock. The barrel is aftermarket, octagon to round. Bore is perfect and gun overall is in...
Sniper, "If you don't make a deal with Rick" I wud be interested in knowing what you are asking.
Sniper, What are you thinking of for your renegade? Mark
TC made scopes and mounts that replace the rear sights. They are worthless except to collect dust on a shelf.
Instead of drilling & tapping for a scope base, install it with JB Weld and install rings. If you don't like it a little heat takes it off and no...
Rick, I, and others, have asked what makes this a "tackdriver" with a standard barrel, sights and unaltered action? I own several that have been...
If you pour a lead slug in your barrel all you have to do is put a small threaded rod in the center of the barrel with a rag stop at the end. That...
I have a New Englander with an aftermarket octagon to round 12 gauge barrel on it. Few minor handling marks but the barrel is bright and clean, no...
Sean, Find a short piece of barrel, 3"-4", so you can actually push the patched ball throu and see how your loader works on the patches.
Hope she shoots well for you. Good luck.
Based on what can be seen of the barrel, no thimbles, and the ram rod hole, it may have been a full stock that was cut back. Interesting but I'm...
Forgot to ask; What is the brass"blob" on the lock plate below the nipple bolster?
Was the forearm cut or was it made square and is there a ram rod groove?
Separate names with a comma.
