• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades

A different but entirly correct approach to lock bolts

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Feb 5, 2007
Messages
167
Reaction score
265
Location
Fort Collins
When doing my initial research for variations of a Hawken full stock, I came across this alternative to using the traditional two lock bolts from the off side of the lock panel. Took me a while to get my mind wrapped around the process and it initially cost me a main spring and lock plate. My first attempt failed because I didn't precisly measure the location for the screw. Drilled through the lock right into the head of the main spring. Got it right this time.

The screw is a 6-40 out of an old lock. I needed to dressed it down to the right length. It's tapped into a flat on the breech tang. The result is a lock that is really tight against the side flat of the barrel and the opposite panel is now ripe for some creative decoration or inlay absent the heads of the usual through bolts. BTW, the screw doesn't interfere with the hook on the barrel breech and there isn't any of the finessing drilling a front bolt hole trying to hit that web of wood between the RR channel and the bottom flat of the barrel inlet.


6-40 screw inset.jpg
 
Last edited:
I think that is pretty dang good ! I had to read it over three times. It just seemed to make more sense each time I read it. It would be interesting to see how it all turns out. :cool:
 
FWIW This is how close to the edge of the tang flat the drill/tap came. The rough chip out on the edge was where the first attempt came through the lock plate and tore out the head of the main spring.
lock screw breech tap.jpg
 
Last edited:
Back
Top