• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades

Angled touch hole

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Bucky182

36 Cl.
Joined
Jul 15, 2019
Messages
86
Reaction score
28
I have an old CVA with a Junkar barrel on it my dad bought me some 40 years ago. Was playing around with it and drilled it to put in a new touch hole liner from Mr. Jim Chambers as it always had an ignition problem. Once I drilled it out I noticed the original touch hole was drilled at an angle towards the front of the barrel. Also, the new Straight hole had partially hit the breech plug. It seems that they did this on purpose. I have read that the breech plugs on these barrels are very hard to remove. Do you think this will effect the ignition of the gun? I don't think it will effect the safety of the gun as the breech is screwed in pretty deep. But am not sure. Have any of you ever seen a touch hole drilled at an angle before? Please let me know your thoughts. Thank You in advance.
 
The first two kit guns I built back in the mid 1970s were CVAs made by Jukar. The location of the lock and barrel were predetermined. The instructions advise to drill the touch hole at an angle if needed to clear the front of the breech plug. Those are both long gone. A few years ago I acquired a used flint pistol made with one of those kits. The touch hole on it is pronounced drilled at a 30 degree angle. So the angled touch hole wouldn’t be uncommon. Now as far as the liner, it the hole you drilled cut a slight bit off the face of the breech plug it shouldn’t be a problem.
 
Back
Top