• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades

Ramrod will not go back into place and is sticking out beyond front of barrel. Help!

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I am not sure how to remove the barrel. At the range I did ask some who also shoots bp/ml and he said it looks like barrel won't come off because of small pins (will post pictures later) as far as custom work don't know. Bought it used.
It was thought that these were pins that would not allow to remove barrel
 
I am not sure how to remove the barrel. At the range I did ask some who also shoots bp/ml and he said it looks like barrel won't come off because of small pins (will post pictures later) as far as custom work don't know. Bought it used.
Believe there are 2 cross pins that need to be tapped out, 2 screws in the muzzle cap, and 1 screw in the tang.
 

Attachments

  • 20220626_173713.jpg
    20220626_173713.jpg
    94.9 KB · Views: 0
69D9CA6F-7E9E-4071-A488-C02C7BDDF0F7.png

Here is a picture of the spring/clip I pulled from Deer Creek products. The darn things can bend if they get wedged. My guess is yours is stuck in the ramrod hole in the stock.
 
If you find your gun had spring/clip, you will have to install it correctly, though I don’t remember that clip in the CVA Kentucky (I know it was used in other models), but I haven’t looked at one in over 30 years.

If you confirm there is no clip, likely just a sharp edge or a wood splitter hanging up the ramrod. If you find the ramrod hole in the butt section is clear, rounding or chamfering the ramrod a bit should do the trick. Once the sharp edge is removed it shouldn’t hang up any more.
 
That looks like the clip. Front lock screw goes through the hole in it. Find them a PIA. You may want to see how the ramrod stays in place with out it, otherwise you will have to hold it in place with a screw a pin while you put things back together. It’s likely easier to assemble if the entire stock is removed from the barrel, but doable if you are careful. Then once together, remember not to remove the front lock screw from the stock in the future or you will have to repeat this experience.
 
The ramrod should pass under the spring/clip. The clip retains it by pushing down on the rammer, friction. I can't tell from the photo but it could be bent or in upside down. It looks like you have a small crack in the stock. right side in front of the lock plate.
 
Look at that! It fits right!!! Woo-hoo! Thank you! thank you! thank you! Thank you for your help! This has been a great learning experience (an all day one..lol) will be firing it again on the 4th and know now what to do. Thank you all so much.
 

Attachments

  • 20220626_181039.jpg
    20220626_181039.jpg
    205 KB · Views: 0
Back
Top