• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades

Rust bluing results

Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

bakerjw

32 Cal
Joined
Mar 10, 2021
Messages
33
Reaction score
40
I am in the end stages of building my Traditions .50 cal Kentucky rifle kit. Still waiting for BLO to fully dry.
Some like the dark brown rust look; however, I wanted this to be blued, so last weekend, I undertook the rust bluing of the barrel. I used the rusting compound from DGW.

In preparation, I wet polished the barrel with 600 grit sand paper before thoroughly cleaning it with soap and water and a final wash of acetone. All contact was with nitrile gloves. Clean is a big key to success. An application of the rusting compound and a moist shower gave a nice light rust layer. A boiling and light rub with clean 0000 steel wool produced the start of a nice black color. Each successive treatment of the rusting compound gave a deeper rust and thus deeper black.

After 4 treatments, it was a deep black color with a lustrous sheen as seen here.
I was more than pleased with the final result.

Barrel.jpg
 
Thanks... I was THRILLED with the results. Now, next Tuesday I will show up and shoot with the black powder guys at the range so that they can see the havoc that they have wrought.
 
I am in the end stages of building my Traditions .50 cal Kentucky rifle kit. Still waiting for BLO to fully dry.
Some like the dark brown rust look; however, I wanted this to be blued, so last weekend, I undertook the rust bluing of the barrel. I used the rusting compound from DGW.
After 4 treatments, it was a deep black color with a lustrous sheen as seen here.
I was more than pleased with the final result.
Nice job!! I hope my soon to be rust blued barrel turns out that good!
 
One thing that I found. For the first boil, I had the stove running. It was an electric range. The rust on the bottom of the barrel came off and I can only assume that it was too much radiated heat or magnetic flux from the electric elements. Subsequent boils were not boiling but very close to doing so.

Nice job!! I hope my soon to be rust blued barrel turns out that Good!

As I mentioned, cleanliness is the key. When I started polishing the barrel with wet 600 grit sandpaper and then cleaning it, I wore gloves every step of the way.
Also, the first rust layer was kind of light but later treatments were a lot heavier looking.
 
One thing that I found. For the first boil, I had the stove running. It was an electric range. The rust on the bottom of the barrel came off and I can only assume that it was too much radiated heat or magnetic flux from the electric elements. Subsequent boils were not boiling but very close to doing so.



As I mentioned, cleanliness is the key. When I started polishing the barrel with wet 600 grit sandpaper and then cleaning it, I wore gloves every step of the way.
Also, the first rust layer was kind of light but later treatments were a lot heavier looking.
What did you use to put the barrel in for the boil?
 
Back
Top