twisted_1in66 said:A couple of caveats I have about the Traditions: one is that they use a "V" spring in the ramrod channel to hold the ramrod in place. It works quite well, but they use the forward lock screw to hold it in place and darn thing falls out of place if you remove the forward lock screw. If your ramrod is in the channel at the time, you can't get it out. If it's out of the channel, you can't get it in.
They warn you in the manual to put a piece of tape over it to keep it from falling out when you remove the lock for cleaning, but that screw is going to come out (and it does). Then you have to remove the barrel by removing the barrel pins and set the thing back into place with the lock installed to clear that ramrod channel. I had that happen often enough over the years that I drilled a hole and installed a pin right in front of the lock to hold it in place instead of using that darn lock bolt.
Another caveat is the big Roman nose on the butt. Since it is a straight stock with no offset, most people lean over the top of the stock a bit to line up the sights. If you do that with this rifle it will bruise your cheek from the recoil.
There are two "tricks" to shoot this rifle comfortably. One is to make a point of putting your cheek on the rifle farther back behind the Roman Nose a bit. The other is to place your cheek on the cheeckpiece like you normally would but turn your nose in towards it. Then you sight out of the corner of your eye and the recoil slides the butt along your cheek instead of slamming up into it with the recoil. That's an old shotgunner's trick and it works well with any Roman Nose stock.
It also likes a heavy load. Mine, and most other folks I've spoken to who have the rifle, seems to like a 95-gr. load to shoot it's best. By comparison my Early Lancaster rifle likes 80-grs.
Hope that helps.
Twisted_1in66 :thumbsup:
Dan
Al Rittenhouse said:There is one for sale at Gun Works in Oregon
bones92 said:The Traditions Penn rifle is well made for a factory gun. I had one but sold it. I could never get a comfortable cheek weld... it needed more drop at the comb in order for me to align the sights. Maybe I just have a big head...
Enter your email address to join: