Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.
Obviously their "in spec" and your "in spec" are two different worlds. Every since sights have been put on barrels there's been some kind of pinning or bending going on to keep sights in place.
Sharp edges on rifling is nothing new. One old remedy is to wrap steel wool around your worm and run it in n out like your cleaning.
Mink oil in Oklahoma melts like ice cream. 50/50 by volume bees wax and cooking oil. Best lube out there.
Look fellas. This is a real simple sport. I've been shooting BP since the early 70's. If a mistake could be done, I've made it. Lube is nothing fancy. In Oklahoma we have to deal with high high temps if your out shooting in the summer. Commercial oil based lubes melt.
By volume mix beeswax and...
My first build was a Sitting Fox fowler. Had to inlet the lock. A little more wood removal to get the look I wanted. Otherwise the stock has a lot of curl. Gun shoots great with ball or shot. No complaints
Everybody has a preference. I determine the optimal patch thickness by ease of loading and accuracy. I also make my patch lube. Been shooting bp since the 70's. Never owned a caliper to measure patch thickness. From a bench I can get 5 shots touching in the center of the target at 50 yards...
I use the largest diameter rod that'll fit down the bore and allow me about 4" longer than the barrel. It makes loading a lot easier. Use your smaller diameter ram rod as a cleaning rod at the range.
Been shooting BP since the early 70's. Never pulled a breech plug. Hot soapy water to clean. Last patch has new motor oil. No rust ever.
Remove you lock. Take outside n spray the insides with brake cleaner. Spray internals with WD40 afterwards. Reinstall.
Wipe the gun down with an oily rag...
Old small horns are typically late 1800's early 1900's. the base plug will have dried up and feels like plastic. Probably has an old tip plug broke off and rattling around on the inside. I'd scrape that paint off it make a plug for the tip n use it. Seal the base with bees wax rolled in the cracks.
2 things right off.
throw away the patches. go to Walmart and buy some pillow ticking. wash it. do not worry about the thickness of the pillow ticking patch. cut it into strips that can be rolled up n kept in your bag.
get some bees wax and cooking oil. 50/50 mix by volume. melt n pour in a...
IN the 1700's and earlier gun metal was left in the white. Sandpaper didn't exist. Stocks were scraped and whiskered to a final finish. As time progressed charcoal bluing of metal was used and then browning. Personally, I absolutely hate a dark blue finish and shiny stocks on a ML'er. That's my...
The movement is caused by the barrel sliding around on the tenon that holds it in the channel. I recommend two things. First I've had tenons fall out. Fix this by cutting a slot in the tenon and the installing a small pin in the barrel channel that will keep that tenon from falling out. Secondly...