• This community needs YOUR help today. We rely 100% on Supporting Memberships to fund our efforts. With the ever increasing fees of everything, we need help. We need more Supporting Members, today. Please invest back into this community. I will ship a few decals too in addition to all the account perks you get.



    Sign up here: https://www.muzzleloadingforum.com/account/upgrades
  • Friends, our 2nd Amendment rights are always under attack and the NRA has been a constant for decades in helping fight that fight.

    We have partnered with the NRA to offer you a discount on membership and Muzzleloading Forum gets a small percentage too of each membership, so you are supporting both the NRA and us.

    Use this link to sign up please; https://membership.nra.org/recruiters/join/XR045103

Pedersoli SxS 10ga bead

L & R
Muzzleloading Forum

Help Support Muzzleloading Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
M

matttdalton

32 Cal.
Joined
Sep 8, 2015
Messages
21
Reaction score
0
I have a Pedersoli SxS 10ga that has a low Point of Impact. Can someone tell me what thread size Pedersoli uses for their beads? I want to experiment with smaller and/or shorter or maybe even no front beads so I can see my target better.
 
You may find it easier to change your cheek position on the stock to raise your sighting eye to see more of the barrel. Your eye is the rear sight on a shotgun, raise the rear sight and raise the impact of the ball.
 
That's unusual, Pedersolis come with a fairly high stock. (Although, Navy Arms had quite number that were stocked lower at one point.) Raising the comb with a strap on pad would achieve what you are after.
 
Or you can put a small wedge under the butt plate to see if it will help. This will either raise or lower the muzzle depending on where you position it - don't make the wedge too large - a small amount will change the impact point greatly. Give it a try.
 
Thank you for the stock raising suggestions. I have already been using a cheek pad comb raising kit and have used all of the shims it has come with. It’s raised the comb about 1/2” and that’s has brought it up to nearly 50/50 POI pattern. I suppose I could get a second one, add more Velcro and shims to keep going higher.

Everyone is probably correct that it’s easier than replacing the bead because so one seems to know and Pedersoli won’t tell me either.
 
take the front sight off , tap for US thread and buy all the beads you need.
 
Before you go off and drill & tap that rib you better remove the bead and measure those threads first. You also want a LOWER front sight not a TALLER one if your gun is shooting low already :v .
 

Similar threads

H
Pedersoli 10ga. barrel gap.
Replies
7
Views
292
ZUG
ZUG
Blackpowderart
Pedersoli 12ga vs 10ga duck range
Replies
13
Views
713
Eterry
Eterry
Acohill1
Pedersoli 12ga question.
Replies
10
Views
441
TCMonts
TCMonts
F
Other options for SxS shotgun sights?
Replies
2
Views
237
sheriff john
S
M
Shot safe for my Pedersoli 10ga SxS?
Replies
2
Views
335
Britsmoothy
Britsmoothy

Latest posts

Back
Top